Agnetic Properties Of Nickel Saturation
- صفحه اصلی
- Agnetic Properties Of Nickel Saturation
The synthesis of nickel nanoparticles using poly(N-vinilpyrrolidone) (PVP) as protective agent was studied.The nanoparticles were prepared in air according to a modified polyol route, using nickel chloride as precursor and sodium borohydride as reducing agent. Samples with different nickel/PVP ratio were obtained. The X-ray diffraction and …
به خواندن ادامه دهید
The saturation magnetizations of very pure iron and nickel have been measured absolutely by a force method at room temperature. The values are 217.6 and 55.1 emu/g (217.6 and 55.1 J T -1 kg -1) respectively. The theory and reliability of the force method are …
به خواندن ادامه دهید
The dielectric behavior of polyvinylidene fluoride (PVDF), nanocrystalline nickel (nc-Ni) composites has been investigated over a broad frequency range of 40 Hz-10 MHz.
به خواندن ادامه دهید
The Ni 0.5 Zn 0.5 Fe 2 O 4 composition has been selected because equal ratio between nickel and zinc gives the maximum saturation magnetization for this type of ferrites [26]. Whereas cobalt introduction into the Ni-Zn ferrite system can improve magnetic properties of the material due to positive magnetocrystalline anysotropy constant.
به خواندن ادامه دهید
Some experiments have reported that the saturation m agnetic moment reduces with decreasing size [8,18,19], while others, ob tained the same value as in the bulk phase [20].
به خواندن ادامه دهید
coupling properties is yet to be examined. In the present study, the experimental data of the ferromagnetic nickel single crystal in the absence and presence of an external saturated magnetic ...
به خواندن ادامه دهید
Some studies in the literature on current and magnetic field sensors stand out. For example, ref. [ 5] proposed a sensor using a Mach–Zehnder interferometer in optical fibers, incorporating Nickel Ferrite (NiFe 2 O 4) nanoparticles with an average …
به خواندن ادامه دهید
display favourable m agnetic properties, and m ay possibly in the future b e laid down as self-assem bled magnetic arrays and a s thin films. Institute of Physics Publishing Journal of Physics ...
به خواندن ادامه دهید
The soft chemical method was adopted to prepare of cobalt-substituted nickel-zinc ferrites (Ni0.95-x Zn0.05COx Fe2O4 for x = 0.01, 0.02 and 0.03).
به خواندن ادامه دهید
Therefore, by adding a certain amount of nickel, the dielectric properties and magnetic properties can be adjusted to a certain balance point. NdFe1-xNixO3 material has excellent microwave ...
به خواندن ادامه دهید
Several ionically bound compounds have been discovered to be ferromagnetic. Some of these compounds are electrical insulators; others have a conductivity of magnitude typical of semiconductors.Such compounds include chalcogenides (compounds of oxygen, sulfur, selenium, or tellurium), halides …
به خواندن ادامه دهید
Yoshizawa and coworkers [12.207,208,209,210] and Naitoh et al. developed nanocrystalline alloys having excellent soft magnetic properties with low coercivity (<2 A/m), near-zero magnetostriction coefficients, and saturation magnetization of more than 1.3 T. The magnetic properties of these novel Fe-Si-B-Nb-Cu alloys were comparable to those of ...
به خواندن ادامه دهید
A series of cobalt-doped nickel ferrite nanoparticles, Cox Ni1−xFe2O4 (x = 0.2, 0.4, 0.6, 0.8), was synthesized by hydrothermal method at low temperature, and its structural, morphological, and ...
به خواندن ادامه دهید
Material magnetic properties2.1. Mumetal® specifications and sample preparation. Mumetal® is a particular supermalloy, an iron–nickel alloy with an 80 % nickel content. The high nickel content leads to a relative permeability above 100,000 and a coercive field on the order of 1 A/m [27]. This permeability value allows better shielding ...
به خواندن ادامه دهید
In this research, a study between the microstructure and mechanical properties of Cu–10%Al alloy with the single addition of V, Ni, Mn, Nb and Cr at 5 wt% was carried out.
به خواندن ادامه دهید
Keywords: Glancing Angle Deposition, XPS, AFM, M agnetic properties, Nickel thin film ... For a pause duration of 10 s, the saturation cluster density obtained by interrupted-flux deposition was ...
به خواندن ادامه دهید
Request PDF | Magnetic field assisted electrocatalytic oxygen evolution reaction of nickel-based materials | The dominant role of the magnetoresistance effect caused by spin electron scattering in ...
به خواندن ادامه دهید
to a constant value, which is called the saturation magnetization MS or spontaneous magnetization. Below Curie temperature MS(T) against T follows a universal curve: it tends to a constant value as T=0; as T increases, the spontaneous magnetization decreases more and more rapidly. At the Curie temperature the magnetization disappeared.
به خواندن ادامه دهید
Nickel nanoparticles stabilized in aqueous emulsion of copolymers were prepared in a few minutes using polyol assisted-microwave (MW) process. This approach based on the reduction of metal salt (NiCl2·6H2O) in the presence of low concentration of hydrazine hydrate (N2H4·H2O) using a commercial copolymer (latex) as both, reducing …
به خواندن ادامه دهید
The structural, morphological, magnetic, and dielectric properties of MnxCo0.5-xNi0.5Fe2O4 (x=0.0, 0.2, and 0.4) synthesized by sol–gel auto-combustion are reported in this paper.
به خواندن ادامه دهید
The oxides reduce to the corresponded metals by reductant gases such as H 2 and CO and absence of oxygen in fuel-rich condition [35, 36].The reaction between metals results in the formation of intermetallic FeNi 3 phase as follows [37]: (2) Fe+3Ni→FeNi 3. The amount of FeNi 3 phase depends on the amount of nickel …
به خواندن ادامه دهید
The synthesis of nickel nanoparticles using poly(N-vinilpyrrolidone) (PVP) as protective agent was studied. ... Nickel nanoparticles obtained by a modified polyol process: synthesis, characterization, and magnetic properties J Colloid Interface Sci. 2007 Jul 15;311(2):461-8. doi: 10.1016/j.jcis.2007.03.045.
به خواندن ادامه دهید
The synthesis of nickel nanoparticles using poly(N-vinilpyrrolidone) (PVP) as protective agent was studied. The nanoparticles were prepared in air according to a modified polyol route, using nickel chloride as precursor and sodium borohydride as reducing agent. Samples with different nickel/PVP ratio were obtained.
به خواندن ادامه دهید
1. Introduction. Magnetic nanoparticles (MNPs) have been extensively studied over the last half century and continue to sustain interest due to their potential use in fields ranging from high-density data storage [] to biomedical applications [2,3].The unique properties of MNPs derive from the fact that these nanoscale magnets differ …
به خواندن ادامه دهید
The saturation magnetization values are in the range of 40.14–69.29 emu/g and the coercivity lies between 185 and 200 Oe. According to ... morphology, structure, and magnetic properties of the nickel ferrite structures as a function of the iron content. 2 Experimental procedures 2.1 Samples synthesis The Co-precipitation technique has …
به خواندن ادامه دهید
It is not only owing to their outstanding soft magnetic properties including high saturation magnetization (M s), high permeability (μ), high Curie Temperature (T c) and low coercivity (H c) and ...
به خواندن ادامه دهید
stronger than the saturated magnetic field strength of 1400 Oe, is usedtoensurethemagnetic saturation state24.Indentationswiththe magnetic field are first conducted, and then those without the magnetic field. Given the soft magnetic properties (low coercivity and residual magnetization) of nickel, the effect of magnetic
به خواندن ادامه دهید
Magnetic measurements show that the saturation magnetization of the as-obtained products in a 0.3 T external magnetic field is 36 emu/g, less than that of bulk nickel crystal, and the coercivity ...
به خواندن ادامه دهید
(c) The domains of a single crystal of nickel. The white lines show the boundaries of the domains. These lines are produced by iron oxide powder sprinkled on the crystal. Besides iron, only four elements contain the magnetic domains needed to exhibit ferromagnetic behavior: cobalt, nickel, gadolinium, and dysprosium.
به خواندن ادامه دهید
At the beginning, the magnetization is zero, but it begins to rise rapidly as the magnetic field is applied. At high field, the magnetic domains are aligned and the magnetization is said to be saturated. When the field is …
به خواندن ادامه دهید
چه بخواهید با ما کار کنید و چه علاقه مند به کسب اطلاعات بیشتر در مورد محصولات ما هستید، مایلیم از شما بشنویم.
